IRCd Config/Inspircd1.1

Instructions

These are instructions for how to configure your Inspircicd1.1 installation for use with the Mibbit system.

1. Locate the cgiirc module in the inspircd.conf called m_cgiirc.so
   Look for

   <module name="m_cgiirc.so">

   and uncomment it.
2. Locate the cgihost tag below and configure as follows:

1. Choose type as Webirc
2. In the password attribute, enter the appropriate Mibbit password as provided by the administrators.
3. In the mask attribute, enter our IP address 64.62.228.82
   Note: In some cases its been reported that connection from mibbit users were not resolved to the correct address. In some cases this can be fixed by setting the mask to "*". This is NOT recommended behavior.

Your cgihost should look like this:

<cgihost type="webirc" password="Your password here" mask="64.62.228.82">

1. Locate your connection block and add an additional block as follows
   

<connect 
   allow="64.62.228.82" 
   timeout="60" 
   flood="10" 
   pingfreq="120"
   threshold="5" 
   sendq="131074"
   recvq="4096"
   globalmax="30"
   localmax="30"
   port="6660">