Difference between revisions of "IRCd Config/Inspircd1.1"

From Mibbit Wiki
Jump to: navigation, search
Line 10: Line 10:
 
:::'''<cgihost type="webirc" password="Your password here" mask="{{Template:Mibbit_IP}}">'''
 
:::'''<cgihost type="webirc" password="Your password here" mask="{{Template:Mibbit_IP}}">'''
 
:# Locate your connection block and add an additional block as follows<br />
 
:# Locate your connection block and add an additional block as follows<br />
{{Template:Mibbit_IP}}
+
 
 +
    &lt;connect
 +
    allow="{{Template:Mibbit_IP}}"
 +
    timeout="60"
 +
    flood="10"
 +
    pingfreq="120"
 +
    threshold="5"
 +
    sendq="131074"
 +
    recvq="4096"
 +
    globalmax="30"
 +
    localmax="30"
 +
    port="6660"&gt;

Revision as of 21:20, 9 April 2008

Instructions

These are instructions for how to configure your Inspircicd1.1 installation for use with the Mibbit system.

  1. Locate the cgiirc module in the inspircd.conf called m_cgiirc.so
    Look for
    <module name="m_cgiirc.so">
    and uncomment it.
  2. Locate the cgihost tag below and configure as follows:
  1. Choose type as Webirc
  2. In the password attribute, enter the appropriate Mibbit password as provided by the administrators.
  3. In the mask attribute, enter our IP address 64.62.228.82
    Note: In some cases its been reported that connection from mibbit users were not resolved to the correct address. In some cases this can be fixed by setting the mask to "*". This is NOT recommended behavior.
Your cgihost should look like this:
<cgihost type="webirc" password="Your password here" mask="64.62.228.82">
  1. Locate your connection block and add an additional block as follows
   <connect 
   allow="64.62.228.82" 
   timeout="60" 
   flood="10" 
   pingfreq="120"
   threshold="5" 
   sendq="131074"
   recvq="4096"
   globalmax="30"
   localmax="30"
   port="6660">