Difference between revisions of "IRCd Config/Inspircd1.1"
| Line 9: | Line 9: | ||
:: Your cgihost should look like this:<cgihost type="webirc" password="Your password here" mask="{{Template:Mibbit_IP}}"> | :: Your cgihost should look like this:<cgihost type="webirc" password="Your password here" mask="{{Template:Mibbit_IP}}"> | ||
:# Locate your connection block and add an additional block as follows<br /> | :# Locate your connection block and add an additional block as follows<br /> | ||
| − | + | {{Template:Mibbit_IP}} | |
Revision as of 21:15, 9 April 2008
Instructions
These are instructions for how to configure your Inspircicd1.1 installation for use with the Mibbit system.
- Locate the cgiirc module in the inspircd.conf called m_cgiirc.so
Look for<module name="m_cgiirc.so">
and uncomment it. - Locate the cgihost tag below and configure as follows:
- Choose type as Webirc
- In the password attribute, enter the appropriate Mibbit password as provided by the administrators.
- In the mask attribute, enter our IP address 64.62.228.82
Note: In some cases its been reported that connection from mibbit users were not resolved to the correct address. In some cases this can be fixed by setting the mask to "*". This is NOT recommended behavior.
- Your cgihost should look like this:<cgihost type="webirc" password="Your password here" mask="64.62.228.82">
- Locate your connection block and add an additional block as follows
- Locate the cgiirc module in the inspircd.conf called m_cgiirc.so
64.62.228.82
